How to recover data from damaged partition? Partition damage is the last thing for user, however paradoxically, it always happens. Therefore, how to recover lost data from damaged partition have concerned users the most. MiniTool Solution Ltd. developed MiniTool Power Data Recover, a green, fast and highly efficient data recovery software, so as to recover lost data from damaged partition.

Partition damage could probably render users considerable losses not only in terms of time lavished on data, but economically. Partition data loss is likely to bring about tens of millions of economic loss for user. Therefore, user should attach great attention on data protection while using computer.

Causes for partition damage generally include following types:
1. Improper operation
2. Virus attack
3. Installation of defective software

Protective tips to slash rate of partition damage:
1. Be careful of operation, never perform any operation unless you have a good understanding of those operations
2. Be careful of virus prevention, have periodical check and kill of computer virus
3. Purchasing genuine software instead of unknown or pirate ones
4. Using computer correctly, for instance, shutdown system before pulling plug

MiniTool Power Data Recovery is recommended to recover lost data, if partition is damaged even though user have attached close attention to above tips. Download MiniTool Power Data Recovery for free at MiniTool Power Data Recovery Download Center.

To give user a clearer mind of how MiniTool Power Data Recovery recover data from damaged partition, here I give a demonstration of recovering data from partition G.

Download and install MiniTool Power Data Recovery, then run MiniTool Power Data Recovery, after that, user may come to this interface.



Unregistered user should check the red zone and click "Launch Power Data Recovery Free Edition" to enter interface



Choose "Damaged Partition Recovery" module to recover data from damaged partition



Damaged partition G: can' t be opened under Windows, here choose partition G: and click "Full Scan" to scan partition and decide partition structure type, and scanning result will be listed as following picture:



Choose partition with highest software advisable values. And click "Show Files" to enter partition, then original would emerge as follows:



Choose files to be recovered in this interface and then click "Save Files", interface for setting file saving location would prop up as follow:



Click "Browse..." to set saving location, and then click "OK" to start recovery.
Recovery completes when prompt of successful saving pops up. Thus, data of damaged partition is recovered.

• How to recover data from formatted partition?
• How to recover data from RAW hard drive?
• How to recover damaged partition?